SilverStone LC14S Manual

9Remove right-front panel slowly and carefully as indicated in the photoInsert optical drive into the top slot ofthe 5.25” drive bay1112Entfernen Sie

10Insert the second optical drive or other 5.25” drive bay device intothe bottom slotSecure both 5.25” drives or deviceswith screws1314Setzen Sie das

11When reinstalling right-front panelback onto the case, make sure thepush-pin on the panel is aligned with the catch in the case.Secure the right-fro

12A second 3.5” drive bracket is located beneath the 5.25” drive bays with room for one more hard drive. It can be taken out of the case easily with a

13Secure reinstalled bracket with screwFor extra EMI protection, route frontpanel cables through the included wire ring192021Schrauben Sie die Halteru

14Insert the connector from the hotkeymodule into a USB pin header on yourmotherboard (please refer to your motherboard manual for connection informat

May, 2008

1

2

3

4Unscrew four case screws to removecase coverLösen Sie die vier Schrauben an der hinteren Abdeckung und entfernen Sie dieseDévissez les quatres vis po

5Power Supply Installation-Insertpower supply into the case, securewith four # 6-32 x 6 screwsMotherboard Installation- Insertincluded motherboard sta

6Place motherboard into the case andsecure with M3 screwsRemove 3.5” drive bracket locatedbehind the acrylic front panel byunscrewing two screws on to

7Prepare your hard drive for installationUse #6-32 x 6 screws to install harddrive into the 3.5” drive bracket, up tothree hard drives can be installe

8After hard drives are installed, placethe 3.5” drive bracket back into the caseand secure with screwsUse hex wrench to remove two hexscrews located o